WoodWynd Flame Powered Extraction Device (Padauk)

DynaVap WoodWynd

NON ELECTRIC FLAME POWERED DEVICE

Arguably one of DynaVpa’s most beautiful dry herb extraction devices yet. The WoodWynd features the stunning Titanium Helix Tip, a completely new Titanium Helix Mouthpiece and XL Condenser and of course that eye catching Wood Stem. DynaVap have opted for a more understated design with this wood stem which really lets the wood shine for what it is. The thinnest part of the wood stem is right at the airport making it extremely easy to locate. The smooth feel of the wood adds a layer of comfort to the feel of the WoodWynd.

Features

• DynaVap Helix Tip: The Helix Tip is constructed out of Titanium, featuring a triple helix design with 3 convection ports which are located on the side of the chamber. This is DynaVap’s lightest tip they have so far created yet has thicker walls than other titanium tips. This adds to its ability to hold heat for longer periods which means you will be up to extraction temperature for longer with each heat cycle. 
• Adjust-A-Bowl: This is a feature of the tip itself. There are 2 positions where the CCD screen can be positioned. One position being full and the other gives you a half bowl size. To adjust the size of your bowl from full to half. Use the included condenser to push it up into the half bowl slot by inserting the condenser tube up through the bottom of the tip. This is done with the tip removed from the stem. Be sure to rest your finger on top of the tip while adjusting so your CCD doesn’t go flying across the room. To move the CCD screen from half to full simply push it back down using the condenser. Keep in mind, constant adjustment often reduces the life of a CCD.
• WoodWynd Condenser & Mouthpiece: Constructed entirely out of titanium and 2 High Temp O-Rings. The WoodWynd Condenser and Mouthpiece are seperate pieces that click together using no o-rings to hold it in place. The WoodWynd Mouthpiece will also allow connection to 10mm female joints.

Below Are DynaVap’s Instructions On Use

• Remove the Cap
• Load your dry herb into the Tip chamber/bowl
• Place the Cap back on the Tip
• Heat the Cap with a torch or Induction Heater until it Clicks (this takes ~5-7 seconds)
• Inhale from the mouthpiece end
• The Cap will click again when it has cooled down
• You can either
• Heat your Cap up again for more extraction
• Save your ABV or later uses (if your bud is done)
• Store your WoodWynd for the next session

The above instruction that DynaVap provide is a great place to start. But if you are new to DynaVap it will take a bit of trial and error to really dial in your technique. Things you will need to experiment with are the use of the airport, type of heat source and how intense that source is. And of course your inhale rate. You will very likely get affective results straight out of the gate. But with some time it will only get better as you really figure out this system.